Conventional Gas
Detector
C-9602LW
Mounting Gas Detector
The installation of gas detector should comply
with all local codes and / or NFPA 72 National
Fire Alarm Code, NFPA 70 National Electrical
Code. Design to install onto standard conduit
electrical box (70mmx70mm). Recommended
location of the detector is show below.
Smoke
Exhauster
1. 5m<L<4m
Gas
Stove
¡ Ý
cm
Liquefied Petroleum
Gas Detector
Floor
Within 30cm
Natural Gas and
Coal Gas Detector
Ceiling
Wiring and Connection
Connect the wires to the required terminal
according to the wire diagram.
K1, K2:
Normally open passive contact, which will
be closed when the detector alarms.
V (+), V (-): Connects with pipe solenoid.
If the detector had alarmed for 3 to 7
seconds, there would be a delayed forward
12V pulse voltage between V(+) and V(-).
Selection of compatible Control Panels
Compatible with all GST Conventional
Control Panels.
Ordering Information:
Part No
Description
Weight/Kg
Pack Qty per Box
C-9602LW-NG
Conventional Gas Detector Natural Gas
.250
100
C-9602LW-LPG
Conventional Gas Detector LPG Low Pressure
Gas
.254 100
C-9602LW-CG
Conventional Gas Detector Coal Gas
.252
100
MANUFACTURED IN ACCORDANCE WITH
Note: Specifications are subject to change without notice.
Power Supply
Knock-off Holes
