8
REMOTE INPUT
GecApp crono Wi-Fi
has a REMOTE input (M3) (Fig. 5) to which you can connect a device or
system to know a specific event such as opening or closing of a valve, blockage of the boiler, an
alarm ... etc.
The REMOTE input is a dry NO contact (Normally Open).
Fig.5
AUX OUTPUT
GecApp crono Wi-Fi
has an
AUX
relay (M5) that allows to activate/deactivate thermostats,
programmable thermostats (
T-Touch, Green
) and many other devices.
The
AUX
relay (M5) (Fig. 6), has 3 voltage-free contacts: COM, NO, NC, able to withstand a
maximum charge of 5A-250Vac.
Fig.6
The AUX output can be set:
- to AUTOMATIC operation (
Auto
):
The auxiliary relay follows the state of the programmable thermostat
GecApp crono Wi-Fi
. If the
GecApp crono Wi-Fi
is set to ON, the
auxiliary relay is ON (Closed).
If the
GecApp crono Wi-Fi
is set to OFF, the auxiliary relay is OFF (Open).
- to MANUAL mode (
ON-OFF
):
If you set the auxiliary Relay to ON, the AUX output will be ON (Closed). If you
set the auxiliary Relay to OFF, the AUX output will be OFF (Open).
The AUX
output can be set via the
App
or via the programmable thermostat
GecApp crono Wi-Fi
in the
Settings MENU- AUX.
ATTENTION: The AUX output
goes to OFF mode If there is no mains voltage and cannot be set.
INSTALLATION
GecApp crono Wi-Fi
can be installed directly on 3 modules or in built-in
box on the wall using the screws supplied (Fig. 7).
In both cases the recommended height is 1.5 m above the floor, in a dry
place, protected from direct airflow and away from heat sources.
N.B. When mounting the section between the BASE and the FRONT
SIDE pay attention to carry out the CONNECTIONS on the back of the
programmable thermostat.
Fig.7
Summary of Contents for Gecapp crono Wi-Fi
