GSM Gecapp crono Wi-Fi, Manual

Page: 33 / 64

33
6
-Insert the data as shown in Figure 4.
Enter a name for the device (es. House ).
Enter the name of the Wi-Fi network connection to which the
programmable thermostat
must be connected.
You can press the key “
I
" to try the Wi-Fi networks
available. When the search is complete, select the Wi-Fi
network.
WARNING:
If there is no
Wi-Fi
network available, after 15
seconds, repeat the operation.
WiFi password
Enter any password (if the network is protected) to connect to
the
Wi-Fi
network.
Fig.
4
Pin
Enter the PIN that allows you to associate in the future to the
Programmable thermostat a further Smartphone/Tablet (see
par. Add Smartphone/Tablet).
The following settings are for advanced users.
We recommend the change thereof only in case of real
necessity.
7
-Press the button on the top right " "to send the settings to the Programmable thermostat .
The programmable thermostat displays the message " Att" (Wait) (Fig. 5) and in a few
seconds, the Home page will appear (Fig. 6).
Fig.5
Fig.6
When the symbol Signal quality “ ” will stop blinking, it means that the programmable
thermostat is connected to the
Wi-Fi
network selected.
On
Smartphone/Tablet
will be thus created a
new device
with its control interface. After a few
seconds the interface is updated with the parameters of the Programmable thermostat and you
can communicate with it.
N.B. If the
Smartphone/Tablet
interface is not updated within one minute, with the STATUS of the Programmable
thermostat, press the icon "
“ and reselect the device you just created.
ATTENTION: When the programmable thermostat connects to Wi-Fi network for the first time,
it runs a set of syncs with the server during which the buttons on the
programmable thermostat
could not be active.
DHCP, IP ADDRESS etc. etc.
Device name
SSID