Grundfos Control MPC 2000 Series, Installation And Operating Instructions Manual, Page: 75 / 528

English (GB)
75
This is the first display shown when connecting to CU 352.
Fig. 141 Connection to CU 352
Factory setting
When you have entered the user name and password, an
application starts up in CU 352, provided that a Java Applet has
been installed on the computer. If this is not the case, but the
computer is connected to the internet, then use the link on the
screen to download and install the Java Applet.
The application on CU 352 exports the Java Applet to your
browser and gives you access to user interfaces such as display
and operating panel.
The Java Applet installation in the browser must be accepted by
the user. You can now monitor and control CU 352 from a
computer.
Fig. 142 Network setting
Change of network setting
When connection to the webserver of CU 352 has been
established, you can change the network setting.
Fig. 143 Change of network setting
1. Click [>Network admin].
2. Enter the changes.
3. Click [Submit] to enable the changes.
Administrator configuration
Fig. 144 Change of user name and password
1. Click [>Admin config].
2. Enter new user name if applicable.
3. Click [Apply].
4. Enter existing password.
5. Enter new password.
6. Repeat new password.
7. Click [Apply].
8.8.2 GENIbus
By installing a GENIbus module in CU 352, you can connect the
system to an external network. The connection can take place via
a GENIbus-based network or a network based on another
fieldbus protocol via a gateway. See examples in fig.
139 . For
further information, contact Grundfos.
The gateway may be a Grundfos CIU communication interface or
a third-party gateway. For further information on CIU, see
Grundfos Product Center, or contact Grundfos.
TM0
3
204
8 0
5
1
7
User name: admin
Password: admin
TM
05
32
3
6
05
17
T
M
03
2
0
5
0
35
0
5
T
M
0
3
2
05
1 0
5
1
7