Grundfos Conex DIA-2, Installation And Operating Instructions Manual

Page: 15 / 612

English (GB)
15
9. Installation
9.1 Transport and storage
• Transport the device carefully, do not drop!
• Store at dry and cool location.
9.2 Unpacking
1. Check the device for damage.
Install as soon as possible after unpacking.
2. Do not install or connect damaged devices!
9.3 Installation requirements
• Dry room
• Room temperature: 0 °C to 45 °C
• Vibration-free location.
9.4 Installation in control panel
Fig. 4 Control panel enclosure Conex
®
DIA-2
Fig. 5 Sensor interface
1. Make an opening of 92 + 0.8 mm x 92 + 0.8 mm
in the control panel.
2. Slip on the supplied gasket.
3. Insert the
Conex
®
DIA-2 into the opening from
the front.
1. Hook the clamps into the tightening cones on the
sides at the top and bottom.
2. Secure the device from the rear using a
screwdriver.
3. Install a separate sensor interface near the
sensors (maximum distance of three metres).
Note
Retainthe packing material or dispose of it
according to local regulations.
Caution
If you do not observe the installation
requirements, the device may be
damaged!
The measurements may not be correct!
TM
03
66
89
45
06
TM
03 66
90 450
6
Caution
Do not damage the gasket!
The gasket must be fitted exactly!
92
+0.8
92 +0.8
> 20
> 20