G0620 Main Control Panel
-17-
MM/Inch Selection
The controller can display units in millimeters or
inches.
To toggle the display between mm and inches,
press the mm/inch
�������
key (
Figure 31
) until the
new unit of measure shows on the control panel.
Figure 31.
Pressing mm/inch key to toggle the
displayed unit of measure.
���
������� �������
�
�����
���
���������
Press and
Release
Checking Battery
To check the remaining battery charge:
1.
Press and hold the F/ENTER
�
�����
key (the
sign will appear as this key is held down),
then press and release the mm/inch
�������
key.
The controller displays the remaining charge
left in the battery, as shown in
Figure 32
.
���
������� �������
�
�����
���
�����
Figure 32.
Current battery charge displayed.
The display will automatically exit out of the
battery charge screen after two seconds.
Changing Resolution
The display can be adjusted to show a resolu-
tion or accuracy from one to four decimal places,
depending on which unit of measure is selected.
To change the resolution:
1.
Press and hold the F/ENTER
�
�����
key (the
sign will appear as this key is held down),
then press and release the mm/inch
�������
key.
The controller displays the remaining power
left in the battery, as shown in
Figure 32
.
2.
At the battery charge display screen, press
the CLR/SET
���
���
key and the F/ENTER
�
�����
key at the same time.
The controller displays the resolution, as
shown in
Figure 33
.
���
������� �������
�
�����
���
Figure 33.
Resolution displayed to two decimal
places.
3.
Use the left and right arrows on the ABS/REL
and mm/inch
�������
keys to select the desired
resolution.
4.
Press the F/ENTER
�
�����
key to exit.
