GLOB Menu Reference
The GLOB menu stores all of the radio-wide settings used by the
scanner. The GLOB menu allows you to “tweak” these settings to
your liking. The default settings will work fine for most users, but
most users will want to use the GLOB menu to personalize the
radio to suit their individual tastes. The active parameter is
always the middle parameter and is indicated by a flashing “
:
”.
The entire GLOB menu is shown below. Note that some GLOB
parameter changes do not take effect until the GLOB menu is
saved.
HINT:
You can restore all GLOB settings to their defaults without affecting
your programmed objects or V-Scanners. Power cycle the radio, then
press 0, then 2 during the welcome message display. Press ENT to
confirm the GLOB parameter reset.
GLOB
Parameter
Options
Description
ATTEN
Global or
Normal
The attenuator reduces the amount of signal at
the receiver input. This helps reduce interference
from strong nearby transmitters. Global
attenuator mode applies attenuation radio-wide,
regardless of individual object settings. In Normal
attenuator mode, the attenuator follows the
individual object attenuator setting.
Global ATTEN
On or off
When the ATTEN mode is set to Global, this
controls whether the Global attenuator is on or
off.
BATTERY
NiMH,
Alkaline or
NiCad
Loads low battery profile for each different
battery type.
SOUND MODE
Key or
Stlth
Controls the key beeps. Selecting Key will
provide a short beep with each keypress.
Selecting Stlth (Stealth) will mute the key beep
sounds.
ALERT MODE
Both, Tone,
Light, Off
Controls the ALERT LED and Audible Alarm
behavior. Both allows the LED and Tone. Tone
allows the audible alarm only. Light allows the
LED only. Off deactivates the ALERT LED and
Audible Alarm feature.
0715 User Manual
"
Page 68
