GRASS VALLEY KMV-3901, Installation & Service Manual, Page: 90 / 138

90
System Configuration
Setting the System Name
settings, information about your housing frame, the input cards and the output card
you are currently connected to.
The multiviewer’s current date and time are shown below in XAdmin, however the date
and time settings are configured through the Densité CPU-ETH2 controller. See
Setting
the Multiviewer’s Time and Date , on page 34.
8 Under General , type the name you want to use for your system.
If there are more than one multiviewer in the same network environment, it is
important to assign each a unique system name, so that you can tell them apart (for
example, when using a remote control panel such as the Kaleido-RCP2 or RCP-200).
Only lower-ASCII characters are allowed in the system name. Braces and tilde are not
allowed.
9 Click Save .
The new settings are saved locally, and XAdmin reminds you to click Apply Setting
before closing your session.
Note:
Under Ethernet , you may review the IP addresses, network mask,
gateway settings, and the detected connection speeds and duplex modes.
Should you want to make any further changes to the network settings, you
may find it more convenient to use XAdmin’s System configuration page,
from now on.