GRASS VALLEY KMV-3901, Installation & Service Manual, Page: 120 / 138

120
Configuring a KMV-3901/3911 Cascade
Connecting the Displays
To install a cascade bridge:
1 Facing the front of the Densité frame where your KMV-3901/3911 cards are installed,
hold the cascade bridge so that you can read the text normally:
2 Align the bridge’s connectors with the matching connectors on the front edge of the
two cards you wish to associate, and then press gently until the connectors are
properly seated:
3 Repeat the procedure if you have a third multiviewer card that is to be part of this
KMV-3901/3911 cascade.
Removing Cascade Bridges
If you need to remove cascaded KMV-3901/3911 multiviewer cards from their housing
frame, you must first disconnect the bridges, while leaving the cards properly seated.
To remove a cascade bridge:
• Carefully pull the cascade bridge straight away from the cards, to disengage the
connectors.
Connecting the Displays
In a KMV-3901/3911 cascade system, you must connect the displays to the appropriate
HDMI outputs on the card that is on the
left when facing the rear of the Densité frame.
Remember that this card is the one on the right when facing the front of the Densité frame.