GRAPHTEC CS610-11eN, Service Manual

Page: 54 / 132

CS610-UM-251-9370 8-10
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
8.8 Drive Rollers
Detaching the front drive roller
(1) Detach the right and left side covers (see Sections 8.1 and 8.2).
(2) Detach the front guide assembly (see Section 8.4).
(3) Detach the top cover assembly (see Section 8.3).
(4) Detach the drive roller belt and the pulley from the drive roller (see Section 8.7).
(5) Detach the E-ring holding the drive roller.
(6) Detach the two bearings holding both ends of the drive roller.
(7) Slide the drive roller to the left, lift up the drive roller from the right side, and then detach it.
Rear drive roller
Front drive roller
Bearing
E-ring
Rear paper sensor
M3L6 binding head screw
Detaching the rear drive roller
(1) Detach the right and left side covers (see Sections 8.1 and 8.2).
(2) Detach the rear cover (see Section 8.5).
(3) Loosen the M3L6 binding head screw holding the rear paper sensor bracket.
(4) Detach the drive roller belt and the pulley from the drive roller (see Section 8.7).
(5) Detach the E-ring holding the drive roller.
(6) Detach the two bearings holding both ends of the drive roller.
(7) Slide the drive roller to the left, lift up the drive roller from the right side, and then detach it.