GRAPHTEC CS610-11eN, Service Manual

Page: 18 / 132

CS610-UM-251-9370 3-4
3. PREPARING TO OPERATE THE SCANNER
3.3 Connecting the Scanner to a Computer
The scanner can be connected to a computer using the USB interface or the Ethernet interface.
The operation of the scanner cannot be guaranteed in the following cases:
• When the cable is connected to a USB hub or an add-on USB board.
• When you are using a custom-built computer or one that you have modified.
The following should never be attempted:
• Remove or reinsert the cable while you are installing the driver.
• Remove or reinsert the cable while starting up the computer or the scanner.
• Remove or reinsert the cable within a period of 5 seconds.
• Remove or reinsert the cable while transferring data.
• Connect two or more scanners to a single computer.
The USB and
Ethernet interface
connectors cannot be used at the same time. Do not connect both the USB and
Ethernet interface
cables to a computer, or to two separate computers, at the same time.
Connecting the scanner via a USB 2.0 interface
(1) Move the interface selection switch to the USB position.
(2) Ensure that you have a USB 2.0 interface cable that works with your computer. Plug the USB 2.0
interface cable into the USB connector socket situated on the right-hand side of the scanner unit.
USB 2.0
interface cable
To the computer
USB
connector
Interface
selection switch
Connecting the scanner via an Ethernet interface
(1) Move the interface selection switch to the Ethernet (LAN) position.
(2) Ensure that you have an Ethernet cable that works with your computer.
Plug the Ethernet cable into the Ethernet connector located on the right-hand side of the scanner unit.
Ethernet
interface cable
To the computer
Ethernet
connector
Interface
selection switch