All the profiles can set pre-defined durations, whereas the expert laundry operator can define
the duration of the module.
The module duration starts when the temperature is reached or when a set temperature must
be reached or once the level is reached in the other cases.
7.3.9 MODULE DURATION
Every module allows you to define how water must be drained. The options available are pro
-
vided below:
•
No draining
•
Standard
•
Recovered
•
Tub cleaning
•
Drain delay 1
•
Drain delay 2
The first option allows you to skip the drain phase for the module you are programming;
therefore, it ends with all the water still in the tub. This water will be used for the subsequent
module, where at the "Water Loading" step, you must set "water from the previous module".
The second option manages the standard draining, i.e. discharge solenoid valve 1, which is
supplied with all the appliances. The third option allows you to open drain 2 (where provided)
for water recovery.
The fourth option allows you to open a third discharge solenoid valve (optional) found in the
recovery tank of the drained water (optional).
Items "drain delay 1 and 2" allow you to keep discharge valves 1 and 2 open for a certain
period while water is entering the tub and the drum is spinning. This is carried out to remove
coarse dirt from the fabric.
7.3.10 DRAIN MODE
Every module allows you to set a spin. The available options are listed below.
•
No
•
Delicate
•
Standard
•
Intense
•
Defined by the user
The first option obviously does not carry out any spinning action at the end of the module. The
second, third, and fourth options allow the profiles to select predefined spin settings according
to the load capacity of the appliances, without involving every single function.
The expert laundry operator can proceed with the fifth option and manually set all the values
related to the spin function.
This way, the following values can be set:
•
Speed
•
Distribution with water
•
Spin time
•
Deceleration
•
Minimum
•
Standard
•
With water
7.3.11 SPIN SPEED
