Repair Manual MSG 90.6PG Commercial Vehicles, Omnibuses – November 2017
Material no. 1153450_c
1.1
Safety instructions
Page 2 of 3
TABLE OF CONTENTS
5 The seat position for repair is "seat lowered (no pressure applied)". If it is necessary to bring the seat to a higher position for
repair work, this position must be secured with suitable spacers (wooden block, fixation with screws or similar structure).
Disregard of these safety measures bears the risk of an accident!
6 When using oil, grease and other chemical substances, the relevant safety regulations for the handling and use of these
products must be observed.
7
WARNING Be careful when removing/installing seats with pyrotechnic belt tensioners:
•
Belt tensioners may only be removed /installed/ contacted when the battery is disconnected and the ignition key
removed.
•
After an accident, the belt tensioner must be checked for external damage, defects and for being triggered. Defective or
damaged components are immediately to be replaced with new ones. It is not allowed to repair defective or damaged
components of the belt tensioner.
•
Install the belt tensioner immediately after it has been brought from the storage room. Not installed units may, in no case,
be stored in the workshop without being supervised by an adequately trained person. If the installation work was
interrupted, belt tensioners must be kept closed or brought back to the storage room.
•
Do avoid the contact of belt tensioners with grease, oil or cleaning supplies.
•
Always protect belt tensioners from flying sparks and naked flames. Do not expose them to temperatures above 100 °C,
not even for a short time.
