Gradall XL3100IV, Operators Safety Manual

Page: 41 / 172

Section 2 - Pre-Operation and Controls
2-17 80804002
• Low Fluid Level - “oL” is displayed (“oL” represents “Fluid (Oil) Level Check”)
followed by “Lo” (“Lo” represents “Low Oil Level”) and the number of quarts the
transmission fluid is low.
Example: “ oL Lo 02” indicates that 2 additional quarts of fluid will bring the fluid level
within the middle of the “oK” zone.
• High Fluid Level - “oL” is displayed (“oL” represents “Fluid (Oil) Level Check”)
followed by “HI” (“HI” represents “High Oil Level”) and the number of quarts the
transmission fluid is overfilled.
Example: “ oL HI 01” indicates 1 quart of fluid above the full transmission level.
• Invalid For Display - If any of the previous conditions are not met, the shift
selector will display “oL” (“oL” represents “Fluid (Oil) Level Check”) followed by
“--” and a numberical display. The numerical display is a fault code and indicates
conditions are not proper to recieve the fluid level information or there is a system
malfunction. The fault codes that may be encountered are shown below:
*A number between 8 and 1 that flashes during countdown period.
**Report sensor failure display to a distributor or dealer in your area.
TRANSMISSION DAMAGE. A low or high fluid level
can cause overheating and irregular shift patterns.
Incorrect fluid level can damage the transmission.
• To exit Oil Level Function, press any range button (R, N, D).
OAC1810
OAC1820
OAC1830
oL, - -, OX*
oL, - -, 50 or, EL
oL, - -, 59 or, EH
oL, - -, 65 or, SN
oL, - -, 70 or, TL
oL, - -, 79 or, TH
oL, - -, 89 or, SH
oL, - -, 95 or, FL Setting time too short
Engine speed too low
Engine speed too high
Neutral must be selected
Sump fluid temperature too low
Sump fluid temperature too high
Output speed high
Oil level sensor failed**
DISPLAY
FAULT CODE
FLUID LEVEL
FAULT CODE DESCRIPTION
CAUTION
OW0031