![background image](http://html.mh-extra.com/html/graco/linelazer-v-200mma/linelazer-v-200mma_operation-repair-parts_2250947038.webp)
LineLazer V LiveLook Display
38
3A9099A Operation, Repair, Parts
Stall Calculator
Stall Calculator is used to set the stall size. The striper
divides the measured length by the stall size to determine
the number of stalls that will fit in the length measured.
User can adjust number of stalls to a round number and
stall width is calculated.
1. Use
to select Layout Mode. Press
to open
Stall Calculator Menu.
2. The most recent length measured in Measure Mode is
automatically displayed. Press gun trigger control to
start a new measurement. Press again to stop
measuring. When measuring between curbs, the
distance from the back tire/curb to the gun/laser dot,
can be accounted for by setting the Offset (x) value.
a. Back the striper up to the curb, then use a tape
measure to measure from where the tire touches
the curb to the laser dot on the ground.
b. Use
to enter the offset (x) value.
c. This value can be stored by holding
for 2
seconds.
d. The value stored under
can be added to the
measured distance before or after the
measurement is taken between the curbs.
e. The offset (x) value can also be adjusted before or
after the measurement is taken by using
.
Stall size and calculated number of stalls are both
adjustable.
3. Press
to return to Layout Mode. The Stall size is
saved and displayed on the Layout Mode screen.
4. Press and release gun trigger control to start marking
dots. Press and release gun trigger control again to
stop.
Ref. Description
1 Opens Angle Calculator Menu.
See
2 Exits and returns stall size to Layout Mode.
3 Measured distance.
4 Calculated # of stalls. Changing the number of
stalls will change the stall size.
5 Adjusts number of stalls.
6 Stall size. Changing stall size changes the
calculated # of stalls.
7 Adjusts stall size.
8 Press to start measurement, Press to stop
measurement.
9 Adjust Offset (x)
10 Stores Offset (x). Hold for 2 seconds to store
value.