Advanced Programming
36
3A8848A
Models with Firmware 6.06 and later for non-DMS models. Models
with Firmware 7.09 and later for DMS models
A12 - Prelube Sequences
This function changes the behavior of the prelube function
to add more lubrication sequences upon pump start up.
While running multiple sequences, after the initial
sequence, PL:xx will be displayed showing how many
sequences are left.
NOTE
: if pump has option “08” and using a pressure
switch with multiple sequences, a vent delay time must
be programmed under Advanced Programming Option
A3.
Prelube LED illuminates (F
1. The default 0001 is displayed.
When Prelube is on, it will run
one sequence.
2. Press the UP or DOWN
ARROW button until desired
number of prelube
sequences displays.
NOTE
:
When prelube is on, and the pump is pow
-
ered-up, the pump will run this amount of lubrication
ON sequences.
3.
Press the ENTER button to exit Advanced
Programming after the last
digit of the
prelube sequence is displayed.
A13- MM:SS OFF Time
This function changes the programming of the OFF Time.
OFF and Warning LEDs Illuminate
1. The default OFF is
displayed.
OFF/Backup time in
setup mode is dis
-
played in HH:MM
(Hours/Minutes).
2. Press the UP or DOWN
ARROW to change OFF to
ON on the display. The
OFF/Backup Time in setup
mode will be displayed in
MM:SS (Minutes/Seconds).
3. Press the ENTER button to exit
Advanced Programming.
F
IG
. 29
ON
OFF
!
1 2 3
HH
MM
SS
##
MM : SS
HH : MM
2
3
1
P
C
C
P
C
P
C
P
F
IG
. 30
ON
OFF
!
1 2 3
HH
MM
SS
##
MM : SS
HH : MM
2
3
1
P
C
C
P
C
P
C
P
