Software
English, Revision 05, Date: 28.11.2016
39
5.2.2.5
C(A)N-Parameters
This menu enables setting the various CAN Bus parameters. In order to be able to use
the CAN bus interface it is necessary to activate it by pressing
.
Figure 18
Menu: C(A)N-Parameters
NOTE!
The functions
and
refer to a special function that is not part
of the scope of the current documentation.
Entering
enables the generation of telegrams either as standard frames according
to CAN2.0A or as extended frames according to CAN2.0B. Correspondingly it is pos-
sible to either set the identifiers (CAN addresses) as 11 bit value (0-2047) or as 29 bit
value (0-536870911).
The identifier selectable under
corresponds to the transmitted frames for the Mes-
sage Object 1 (Table 9 on page 24). The identifier selectable under
refers to the
Message Object 2 (Table 10 on page 24). Input of 0 deactivates the corresponding
Message Object.
CAN
audrate: You can either select a predefined data rate or configure the bit timing
with
/
/
/
. The resulting baudrate and sample point are displayed immediately.
NOTE!
Usually the predefined baud rates should work for most applica-
tions. Only change the bit timings if you really know what you do!
switches between a permanent output period
with (
1
) and only generating the
output whenever a Transponder is decoded within the field (
0
).
SR = 01: STUFF ERROR / / / /
(!)Antenna-ID: front (01)
(C)AN active YES
(E)xtended CAN STANDARD
(Y)dentifier: TX [0..2047]: 10
(D)-Identifier: TX [0..2047]: 0
(S)-Identifier: TX [0..2047]: 0
CAN-(B)aud [20,50,125,250,500,1000 kB]: 1000.0
B(R)P Baudrate Prescaler [0..63]: 0
S(J)W Sync Jump Width [0..3]: 0
Tseg(1) [2..15]: 6
Tseg(2) [1..7]: 1 sp: 70 %
(P)eriod [4.500mS]: 8
Co(n)tinous Telegrams 1
CAN on Re(m)ote Request 0
(F)reeze Values for n Telegrams [0..20]: 0
(O)rder of Data Transfer (0= HiByte first): 0
(Q)uit Menue
