Software
English, Revision 05, Date: 28.11.2016
29
If you are using a different port than
COM1
with HyperTerminal, then adjust the port as
follows:
1.
Select Properties from the menu file (or click the Icon
). The following window
appears:
2.
Choose the direct connection to the respective port via the submenu
direct
connection
. Confirm with
. Save the altered values if you are asked for it
while exiting HyperTerminal.
5.2
System Monitor
In
monitor mode
the system can be configured using the corresponding menu. To use
the monitor mode you need to know which protocol is set in your antenna.
The possible communication procedures are:
Terminal settings monitor program (refer to section 5.2)
baud rate
19200 or 38400 Bd
depending on the system configuration, default
38400 Bd
terminal emulation
VT52
parity
even
data bits
8
stop bits
1
character delay
1 ms
line delay
0 ms
PC interface (port)
COM1
can vary depending on the PC (see below)
Table 19
Terminal settings for the monitor program
