User Manual
25
6.6.2 SIP 1 Configuration
User can configure specific parameter of SIP1 on this page:
Definition of each parameter described as below:
SIP[Unregistered]
Configuration
SIP register state
；
if register successfully, show
“Registered” in the square bracket
，
otherwise show
Unregistered
RegisterServer address
Set SIP register server IP address
Proxy Server addr
Set proxy server IP address
（
usually SIP will provide the
same configuration of proxy server and register server,
if different(such as different IP addresses), then each
server's configuration should be modified separately
）
Register Server Port
Set SIP register server signal port
Proxy Server Port
Set SIP proxy server signal port
Register Username
Set SIP register server account username
（
Usually it is
the same with the config port number
）
Proxy Username
Set the SIP proxy server account username
Register Password
Set password of SIP register server account
Proxy Password
Set password of SIP register account
Domain Realm
Enter the sip domain if needed, otherwise EP310-H will
use the proxy server address as sip domain. (Usually it
is same with registered server and proxy server IP
address).
Local SIP Port
Set local signal port
，
the default is 5060
Phone Number
Set assigned phone number
Register Expire Time
Set expire time of SIP server register, default is 60
seconds
Detect Interval Time
Set detection interval time of server, default is 60
seconds
RFC Protocol Edition
Enable the phone to use protocol edition. When the
phone need to communicate with phones using SIP1.0
such as CISCO5300 and so on, need to change to
