Global Power Technologies
6-10
5120
k)
Rotate the flame arrestor
element so that the two
holes align with the flame
arrestor extension studs.
Install two (2), #10 flat
washers and 10-32 wing
nuts, then tighten.
6 .4 .2 Install Flame Arrestor Stack
and Thermocouple:
Figure 37 shows the installation
of the Flame Arrestor inner stack
and thermocouple.
a)
Carefully place the high
temperature gasket over
the combustion chamber
exhaust tubes . The gas-
ket is CRITICAL for proper
operation. Do not use it if
it is damaged. Obtain
a new gasket, GPT P/N
3400-50198 if required.
b)
Install the stack spacer sleeve over the 10-32 stud protruding from the burner cover
plate, directly below the exhaust tubes. The spacer is CRITICAL for proper operation.
Obtain a new spacer, GPT P/N 4900-50196 if required.
c)
Carefully install the flame arrestor inner stack assembly over the burner cover exhaust
tubes and the 10-32 stud protruding from the burner cover plate, until it contacts the
high temperature gasket. Install the coupling extension wing nut (4500-50225) on the
combustion chamber stud and tighten. Check that the gasket is compressed evenly.
d)
Install the thermocouple into the mounting boss on the right side of the inner stack
assembly. First, tighten the thermocouple lock nut finger tight only. Then, support
the mounting boss with a 5/8 wrench and snug the thermocouple lock nut with a 7/16
wrench.
WARNING: Do not twist the inner stack assembly when installing the thermocou
-
ple, or the gasket may be damaged.
e)
Loosely install the electrode mounting pin and large wing nut into the electrode bracket
on the front of the inner stack assembly.
Figure 37
Flame Arrestor Stack and Thermocouple
Installation
Summary of Contents for 5060
