![background image](http://html.mh-extra.com/html/global/5060/5060_operating-manual_2232476049.webp)
Global Power Technologies
4-2
5120
4 .2 Operation
4 .2 .1 Preparation for Use
The power conditioner is shipped ready for operation. If the limiter converter was shipped sep
-
arately, it should be inspected for obvious dents or broken components. Notify the carrier if so.
4 .2 .2 Installation
The standard mounting location is on the right side
of the generator cabinet. Remove the nuts and lock
washers and mount to the outside of the cabinet.
Feed the wires into the cabinet through the hole pro
-
vided. Refer to Figure 26 to identify the input and
output wires.
Check the selector switch setting (Figure 26)
BEFORE connecting the input or output wires to the
terminal block.
Connect the 220 Watt L/C to the terminal block as
per Figure 25.
Remote mounting of the limiter converter is accept
-
able, but allow for 17 Amps between the generator
and the limiter converter when sizing wire.
The limiter converter must always be mounted in an
upright position to allow air to pass freely over the heat sink section.
4 .2 .3 Output Voltage Adjustment
The 220 Watt limiter converter is factory set at 14.1 Volts or 27.0 Volts depending on the output
ordered. To trim the output voltage use the output voltage adjustment pot shown in Figure 26.
To change the output voltage range use the selector switch in Figure 26.
4 .2 .4 Protective Limiter
A protective limiter circuit is incorporated into the 220 Watt L/C to limit the input voltage. This
setting can be measured across the TEG POS and TEG NEG terminals with no load connect
-
ed. The 220 Watt L/C is factory set at 10 Volts for a 5120, 16 Volts for a 5220 and 9 Volts for
a 5060. When using a 220 Watt L/C on a generator other than what it was factory set for, the
protective limiter must be readjusted at the factory.
4 .2 .5 Voltage Sensing Relay Adjustment
The VSR is factory set at 11.5 Volts for 14.1 Volt output and at 23.0 Volts for a 27.0 Volt output.
Should this require adjustment, use the VSR adjustment pot in Figure 26.
Figure 25
5120 Wiring Diagram
Summary of Contents for 5060
