Global garden products N 102 Hy Series, Workshop Manual

Page: 59 / 80

MAP
1 / 2
6.8.
0
REPLACEMENT OF THE SUPPORTS
AND SHAFTS OF THE BLADES
General informations:
---
Related topics:
Special tools [ 2.2]
Removing the blades [ 4.8]
Removal of the cutting deck [ 5.7]
Removal of blade control belt [ 6.6]
Removal of blade connection belt [ 6.7]
Tightening torques
2 Screws for plate fastening ................. 30 ÷ 35 Nm
5 Nuts for flange support
fastening .......................................... 25 ÷ 30 Nm
1 2 2 2
3 2
4
5
6
4
7
• Remove the cutting deck.
NOTE
This operation is not strictly necessary as, with a little
practice and experience, it is possible to dismantle
the deck supports without removing the deck.
• Remove the blade control belt.
• Remove the blade connection belt.
• Remove the blades and take off the hubs.
Pull out the two cogged pulleys (1) from the blade
shafts, unscrew the seven screws (2) that fix the plate
(3) and remove it.
Dismantle the flange support (4) by unscrewing the
three fastening nuts (5).
The entire support (4), including shafts and
bearings, is a spare part available as single
assembly unit.
If you should want to just replace the shaft or bear-
ings, remove the key or the two keys (6) and hit the
shaft with a plastic mallet on the pulley side in order
to remove the shaft together with the lower bearing
(7).
MODEL YEAR 2016
N…102 Hy N…102
WORKSHOP MANUAL
WORKSHOP MANUAL
BACK