WORKSHOP MANUAL
WORKSHOP MANUAL
N…102
N…102 Hydro
i.
3
INDEX
GENERAL INDEX
1.
Rules and procedures for Service Centres
1.1 0 Identification and procedures
2.
General and safety regulations
2.1 0 Safety regulations
2.2 0 Tools
2.3 0 Lifting
2.4 0 Vertical positioning
2.5 0 Practical hints
3.
Maintenance
3.1 0 Criteria for maintenance
4.
Adjustments and tuning
4.1 1 Adjusting the engagement
and checking the blade brake
4.2 0 Brake adjustment
4.3 0 Drive belt adjustment
4.4 0 Drive pedal adjustment
(
hydrostatic drive models only
)
4.5 0 Aligning the cutting deck
4.6 0 Steering geometry adjustment
4.7 0 Checking blades alignment
4.8 0 Removing, sharpening and balancing
the blades
5.
Removal of external parts
and main assemblies
5.1 0 Removal of front hood
5.2 0 Removal of the wheel cover
5.3 0 Removal of the ejection conveyor
5.4 0 Removal of the tank and replacing
the fuel pipe
5.5 2 Removal of the engine
5.6 1 Removal of the rear axle(Peerless MST
205-535 E - Tuff Torq K46S)
5.6a 0 Rimozione dell’asse posteriore (Hydro-
Gear T2-ADBF-2X3C-17X1)
5.7 0 Removal of the cutting deck
6.
Repairs
6.1 0 Replacement of tyres and wheels
6.2 0 Replacement of front wheel bearings
6.3 0 Dismantling steering components
6.4 0 Replacement of the drive belt
6.5 0 Replacement of the small wheels
for the drive belt
6.6 0 Replacement of the blades belt
6.7 0 Replacement of blade connection belt
6.8 0 Replacement of the supports and shafts
of the blades
6.9 0 Replacement of the accelerator
6.10 0 Replacement of the brake pads and disc
(
mechanical drive models only
)
7.
Electrical system
7.1 0 Troubleshooting of the electrical system
7.2 0 Summary table for the cutting in of the safe-
ty devices
7.3 1 Safety microswitches operation check
7.4 0 Terminal board supply check
7.5 0 Electromagnetic clutch operation check
7.6 0 Starter relay operation check
7.7 0 Electronic card operation check
7.8 0 Recharge circuit check
7.9 0 Care and maintenance
of the sealed battery
7.10 1 Fitting safety microswitches
7.11 1 Electrical diagrams
8.
Technical specifications
8.1 2 Tightening torques and adjustments
summary
8.2 0 Belts assembly
2 / 2
BACK
