2 / 2
4.5.
0
ALIGNING
THE CUTTING DECK
General informations:
Lowering of the cutting deck is controlled by a link-
age operated by the lever and is guided by two front
articulation connecting rods.
In order to get a good cut it is essential that the cut-
ting deck is parallel with the ground crosswise, and
slightly lower at the front.
a)
a combined adjustment to the parallel and the
minimum height front and back
b)
adjusting the regularity of raising and lowering
Related topics:
Special tools
Tyre pressures
Front ........................... (Tyres 13 x 5.00-6) 1,5 Bar
....................... (Tyres 15 x 5.00-6) 1,0 Bar
Rear ............................................................ 1,2 Bar
10a
5
11
12
7
1
4
6
8
10b
3
456 - 458 mm
9
9
Turn the nuts (9) until there is a 456-458 mm distance
between the two pins (10a) and (10b).
Turn the nuts (9) so that the rear left screw (4) starts
moving at the slightest movement of the lifting lever,
and then secure it in place;
Screw down the rear left screw (4) until the rear edge
of the cutting deck begins to rise;
Screw down the front nuts (6 - 8) until the front edge
of the cutting deck begins to rise evenly, both on the
right and left side.
Screw down the three locknuts (3 - 5 - 7).
Check that the deck rises and lowers regularly as
indicated in point “
B
”.
B) Adjusting the regularity of rising
and lowering
When the adjustment as at point “A” has been made,
put the control lever in 2 or 3 different positions and
check that the deck rises evenly and that at each
position it constantly maintains the difference in
height from the ground between the front and back
edges.
If the front edge tends to rise before or after the back
edge, turn the nuts (11) on the connecting rod (12);
tighten the nuts, the front edge will rise first, while if
you loosen them, the back edge rises first.
When you have finished the adjustment, always
check that all the nuts and locknuts are tightened
securely.
MODEL YEAR 2016
N…102 Hy
N…102
WORKSHOP MANUAL
WORKSHOP MANUAL
BACK
