1 / 1
5.7.
0
REMOVAL
OF THE CUTTING DECK
General informations:
Removing the cutting deck facilitates all the over-
haul and replacement of hubs, bearings and blade
shafts. With some practice and experience it is pos-
sible to do this work with the deck still in position.
Related topics:
Aligning the cutting deck
[
4.5]
Removing the ejection conveyor
5.3]
Tightening torque
3
Steering rod fixing nut ........................ 18 ÷ 20 Nm
2
1
4
3
6
6
5
5a
• Remove the collector channel.
Free the blade belt (1) from the clutch pulley (2) and
set the cutting height adjustment lever to position
«1».
Unscrew the nut (3) and disconnect the steering rod
(4) to allow the passage of the belt.
Unscrew the two nuts (5) fastening the two arms (5a)
to the frame.
Release the three flexible split pins (6) of the lifting
tie-rods.
Having checked that there are no obstacles, the plate
can be removed, slightly rotating it anticlockwise, so
that all the pins come out of their housings.
For reassembly perform the operations described
above in reverse, making sure making sure to tighten
the nuts (5) so as not to hinder correct cutting deck o-
scillation.
When assembly is completed …
• Reattach the collector channel
• Check the alignment of the cutting deck
MODEL YEAR 2016
N…102 Hy
N…102
WORKSHOP MANUAL
WORKSHOP MANUAL
BACK
