1 / 2
4.5.
0
ALIGNING
THE CUTTING DECK
General informations:
Lowering of the cutting deck is controlled by a link-
age operated by the lever and is guided by two front
articulation connecting rods.
In order to get a good cut it is essential that the cut-
ting deck is parallel with the ground crosswise, and
slightly lower at the front.
a)
a combined adjustment to the parallel and the
minimum height front and back
b)
adjusting the regularity of raising and lowering
Related topics:
Special tools
Tyre pressures
Front ........................... (Tyres 13 x 5.00-6) 1,5 Bar
....................... (Tyres 15 x 5.00-6) 1,0 Bar
Rear ............................................................ 1,2 Bar
11 - h = 26 mm
12 - h = 32 mm
1
2
5
11
12
7
1
4
6
8
3
Check the tyre pressures. If one or more tyres have
been replaced or you find differences in diameter,
do
not attempt to compensate these differences by
giving different tyre pressures
, but make the ad-
justments as in point “
A
”.
NOTE
- When aligning the cutting plate it could be
necessary to remove the belt guards; in this case
the
guards must always be replaced after adjust-
ment
.
A) The combined adjustment to the parallel
and the minimum height front and back
Put the lawn-tractor onto a flat and stable surface
(such as a work bench) and put blocks beneath the
cutting deck in line with the centre lines of the blades:
– at the front 26 mm (1)
– at the rear 32 mm (2)
Put the height lever in position «1».
Fully unscrew the locknuts (3 - 5 - 7) , screw (4) and
nuts (6 - 8) so that the deck rests on the blocks.
MODEL YEAR 2016
N…102 Hy
N…102
WORKSHOP MANUAL
WORKSHOP MANUAL
BACK
