Global garden products MJ66, Workshop Manual

Page: 60 / 88

MAP
2 / 3
6.5.
1
REPLACEMENT OF THE SUPPORT
AND SHAFT OF THE BLADE
The entire support (16), including shafts and
bearings, is a spare part available as single as­
sembly unit.
If you should want to just replace the shaft or bea rings,
remove the key (17a) and hit the shaft with a plastic
mallet on the pulley side in order to remove the shaft
together with the lower bearing (18).
After having removed the snap ring (19), the dust co-
ver (20) and the spline (21), the bearing (22) spli ned
onto the shaft can be removed using a normal extrac-
tor, taking care to close up the threaded hole (23)
with a screw to prevent the point of the ex tractor from
damaging the thread.
The second bearing still in place must be removed by
hitting it from the inside of the flange using a 12 ÷ 15
mm diameter round bar (24).
On reassembling, first put the shaft into the hole of the
lower bearing and insert this into the support. Fit on the
upper bearing and, using the special bush (25) which
works on the inner ring, hit it squarely with a mallet until
the bearing is fully driven home.
General informations
­­­
Related topics
[ 2.2] Tools
[ 4.7] Check on blade alignment
[ 4.8] Removing, sharpening and balancing
the blade
[ 5.7] Removal of the cutting deck
Tightening torques
9 Pulley tightener fixing screw .......... 25 ÷ 30 Nm
14­15 Plate fastening bolts ................ 25 ÷ 30 Nm
17 Nuts for flanged support ............... 25 ÷ 30 Nm
MODEL YEAR 2015
MJ66-Hy MJ66
WORKSHOP MANUAL
BACK