44
Window side glass replacement
When you replace any window glass, always make sure you replace it by an identical
one.
Micro Bird windows are installed from inside of the bus and pushed in their locations.
Cut and remove outside sealant around the frame to allow the window to be released
when pulling from inside the bus.
On G5 models, simply remove the 6 screws fixing the window frame to the bows. On
MBII models, the 6 screws are holding a held in place by a piece called a between which
once removed, will allow the window to be pulled off the bus.
Once the window has been removed, disassemble window by removing the screws which
hold the frame pieces together.
After the glass has been replaced, reassemble window, install in its location and apply
weather seal caulking around the window frame on outside of body to prevent leaking.
Back windows and more-view glass replacement on MBII model busses
On the MBII the side window glass replacement is the same as on a G5 (refer to the
procedures listed above). The more-view and the back windows are installed inside a
rubber trim. Please call your dealer for complete procedure.
Back windows and more-view glass replacement on G5 model busses
On the G5, the side window glass replacement is the same as on an MBII (refer to the
procedures listed above). For more-view window and rear window glass, call your dealer
to get detailed procedures as special preparation is done to ensure adequate adhesion.
Sealant
Screw on bow
or on between
Remove window
