40
Horn activated:
If the chassis horn is activated before or after you leave the bus, the vehicle must be
equipped with a child detection system. The engine needs to be started and the
deactivation button on the rear wall needs to be depressed. This is to make sure the
driver goes all the way to the back to check if kids are still in the bus before he leaves. If
you cannot get the child detection system to disarm, please refer to system information on
page 37 of this manual for help.
Lift door glass replacement
Refer to entrance door glass replacement on page 39 of this manual. The process is the
same.
Light in stepwell or entrance dome light stay on:
The microswitch used to stop the closing of the door needs to be adjusted as it stops the
motor before the door leaves sit tightly against the bus. Slightly bend the tip of the
microswitch to allow the doors to shut tighter.
Light monitor not showing accurate information:
If the light monitor is not showing the accurate data about the outside lights performance,
the first thing that should be done is recalibration of the module.
1.
Start the vehicle and operate all lights for 2-3 minutes to allow system voltage and
lamp temperature to stabilize.
2.
Turn tail lights on.
3.
Momentarily press the PROGRAM SWITCH located on the back of the Bus
Light Monitor. To ensure proper programming,
make sure the brake pedal is
not depressed
while program switch is activated.
4.
Progressively activate lights as follows until they turn off on the light monitor: 4
yellow flashers / 4 red flashers / Left flasher / Brake pedal / Right flasher / and
end the process with the Back-up lights.
5.
Turn off the engine.
6.
Repeat steps 3 to 5 but this time, ensure that the indicator lights on the monitor
turn on when the corresponding lamp is on and the indicator light is off when the
corresponding lamp is off.
Mirrors (outside) not heating:
If the heated mirror does not get hot, first check if the red light is activated on the switch.
If it is, it means there is current from fuse block to switch. Then check if there is current
on the wire going to the mirror and check the grounds. If everything has been checked,
the problem might be with the element in the back of the mirror glass. It is possible to
replace the glass portion of the mirror only.
