34
f.
Try to operate the Awning by putting two Wires together for three seconds, either (WHITE-
RED= Retract), (WHITE-GREEN= Stop) and (WHITE-BLACK= Extend). If the Awning
does not move repeat steps “a” to “f” .
2.
Programming the 98GC104DC to the GC 732G (DC Motor Control)
a.
Connect the Dry Contact Control Module(98GC104DC) to 12 volt DC
b.
Turn on the power to the
GC 732G:
The unit will start beeping for least 5 seconds.
c.
Press the Programming button for a least 3 seconds. See Figure 1. (Red LED will turn on
after 3 seconds).
d.
From the Signal Cable of the 98GC104DC, select the (WHITE and RED wires) put those two
wires together for three seconds: (The LED will start blinking for about 5 seconds),
e.
Try to operate the Awning by putting two Wires together for three seconds, either (WHITE-
RED= Retract), (WHITE-GREEN= Stop) and (WHITE-BLACK= Extend). If the Awning
does not move repeat steps “a” to “e”.
3.
Programming the 98GC104DC to a Remote Motor
a.
Open the Box of the Dry Contact Control Module 98GC104DC (See Figure 2)
b.
Connecto the Dry Contact Control Module (98GC104DC) to 12 volt DC
c.
Turn on the power to the
Remote Motor:
a soft beep will be emitted by the RF receiver in the
unit.
d.
Press twice the P2 button on the back of the Remote, see Figure 2 (A beep will be emitted by
the RF receiver with each press)
e.
From the Signal Cable of the 98GC104DC, select the (WHITE and RED wires) put those two
wires together for three seconds.
f.
Try to operate the Awning by putting two Wires together for three seconds, either (WHITE-
RED= Retract), (WHITE-GREEN= Stop) and (WHITE-BLACK= Extend). If the Awning
does not move repeat steps “a” to “e”.
Note
: If the motor turns in the opposite direction (Extend), repeat “a to e’ but now chose the
(WHITE-BLACK which is the Extend).
Figure 2