10
Programming steps for Manual Remote Control
NOTE:
•
Before starting this procedure the Receiver must be without power (OFF) for at least 10 seconds.
•
During the programming function the interval between each step required must be less than 10 seconds
1.
Programming the GC136 to a Remote
a.
Turn on the power to the
GC136
b.
Press the program button (Fig. 2) using a paper clip or other small tool: the Green LED will start
blinking
c.
Press STOP (Fig. 1): The Green LED will stop blinking and stay on solid
d.
Press the
UP
button on the REMOTE (Control or Unit): The Green LED will turn off.
2.
Cancel one Remote from the GC136
a.
Turn on the power to the
GC136
b.
Press the program button (Fig. 2) using a paper clip or other small tool: the Green LED will start
blinking
c.
Press STOP (Fig. 1): The Green LED will stop blinking and stay on solid
d.
Press the
DOWN
button on the REMOTE (Unit): The Green LED will turn off.
3.
Delete all of the Remotes from the GC136
a.
Turn on power to
GC136
b.
Verify which Button of the
GC136
functions as
DOWN
button (Opens the Awning)
c.
Press simultaneously the
STOP
and
DOWN
button of the GC136 for at least 6 seconds: The
Green LED will first turn on solid and then blink a few times. When the Green LED turns off the
operation is completed.
4.
Program “Continuous” or “Step” mode of operation
a.
Turn on power to
GC136
b.
Verify which Button of the
GC136
functions as
UP
button (Closes the Awning)
c.
Press simultaneously the
STOP
and
UP
button of the
GC136
for at least 6 seconds: The Green
LED will first turn on solid and then blink a few times. When the Green LED turns off the
operation is completed.
NOTE: TO reset to previous mode of operation repeat the three steps above.
Specifications
Power:
110VAC / 60Hz
AC Input:
White = Neutral / Black = Line / Green = Earth
To the Motor:
White = Neutral / Red = Direction 1 / Black = Direction 2 / Green = Earth
Ambient T:
0 - 130°F
Installation
To install the
GC136
select a suitable indoor location then:
1.
Install a 110VAC outlet box to plug in the unit
2.
Bring the Awning’s Motor wires to this location and make the connections to the GC136 wires in a
Junction box or by other means in accordance to NEC requirements
3.
Mount the
GC136
on the wall using the sDCew and tape provided with the unit.