32
Programming steps
NOTE:
•
Before starting this procedure the Receiver must be without power (OFF) for at least 10 seconds.
•
During the programming function the interval between each step required must be less than 10 seconds.
•
The Motion Sensor can only be programmed to a REMOTE that is already programmed to the Receiver.
To Program GC116I to a GC-136 Receiver
k)
Turn on the
GC-136
and the
GC116I
(Leave them on if already on)
l)
Press the
PROGRAM
button on the
GC-136
(the LED will start blinking)
m)
Press the
STOP
button on the
GC-136
(The LED will be on solid)
n)
Press the
UP
button on the
GC116I
o)
Extend awing using a Manual Remote Control and press again the
UP
button on the
GC116I
to
verify that the unit is working properly (the awning should Retract)
To Program GC116I to a Remote Motor or to GC74DC-F
a)
Program first the Remote Control to the
Remote Motor
or the
GC74DC-F
(See Remote Control
programming instructions
)
b)
Turn on the
Motor (or GC74DC-F)
(you will hear a faint beep from the RF receiver
c)
Connect the GC116I to the 12V supply.
d)
Press TWICE the P2 button on the back of the Remote Control
e)
Press ONCE the
SETUP
button on the
GC116I (
A beep will be emitted by the RF receiver with
each press).
f)
Extend awing using a Manual Remote Control and press the
UP
button on the
GC116I
to verify
that the unit is working properly (the awning should Retract)
NOTE:
The Anemometer sends the retract signal to all awnings
simultaneously
and the power
system of the vehicle must withstand the resulting surge of current. The surge is greatest when
all awnings are fully extended. Verify that all awnings will retract under these conditions (fully
extended). If this is not the case you may:
•
Provide sufficient power from your panel or
•
Purchase a Delay Retract Disconnect unit
•
Purchase a Motion Sensor Remote instead of the Anemometer
