19
Programming steps for Manual Remote Control
NOTE:
•
Before starting this procedure the Receiver must be without power (OFF) for at least 10 seconds.
•
During the programming function the interval between each step required must be less than 10
seconds
1.
Programming the GC 732G to a Transmitter (Remote)
a.
Turn on the power to the
GC 732G:
The unit will start beeping for least 5 seconds.
b.
Press the Programming button for a least 3 seconds. See picture 1. (Red LED will turn on after 3
seconds, see picture 2).
c.
Press any button of the Remote Control (The LED will start blinking for about 5 seconds), verify
that the motor is turning in the correct direction. If the motor does not turn in the correct direction,
move the Reverse Switch to the other location (See picture 3).
2.
Cancel all Remotes from the GC 732G (Note: Remotes can’t be cancelled individually)
a.
Turn on the power to the
GC 732G
b.
Press the programming button for a least 5 second the Red LED will turn on and will turn off.
c.
Press any button of the remote to make sure it is cancelled
3.
Additional function…
a.
In order to work properly this unit has a built in a volt detector, so if the voltage of the vehicle is
under 12 volts and the user try to move the awning the unit will emit 2 beeping sounds and stop
the awning until the voltage goes to 12 Volts or more.
4.
Program
98GC1029(Five Channels)
to the GC732G follow step 1, to cancel follow step 2
Note: The
98GC1029 (Five Channels)
is special remote with LED’s control function. See picture 5 below.
Picture 5
