12
•
Only one channel must be programmed at the time and repeat the same steps with the second channel.
1.
Programming the GC228A to a Remote
a.
Remove the front cover to access the programming button.
b.
Turn on the power to the
GC228A
c.
Press the program button (Fig. 2) using a paper clip or other small tool: the Green LED will start
blinking
d.
Press STOP (Fig. 1): The Green LED will stop blinking and stay on solid.
e.
Press the
UP
button on the REMOTE (Control or Unit): The Green LED will turn off.
2.
Cancel one Remote from the GC228A
a.
Remove the front cover to access to the programming button.
b.
Turn on the power to the
GC228A
c.
Press the program button (Fig. 4) using a paper clip or other small tool: the Green LED will start
blinking
d.
Press STOP (Fig. 3): The Green LED will stop blinking and stay on solid
e.
Press the
DOWN
button on the REMOTE (Unit): The Green LED will turn off.
3.
Delete all Remotes from the GC228A
a.
Remove the front cover to access to the programming button.
b.
Turn on power to
GC228A
c.
Press simultaneously the
STOP
and
DOWN
button of the channel that you want delete for at least
6 seconds: The Green LED will first turn on solid and then blink a few times. When the Green
LED turns off the operation is completed.
4.
Program “Continuous” or “Step” mode of operation
a.
Turn on power to
GC228A
b.
Verify which Button of the
GC228A
functions as
UP
button (Closes the Awning)
c.
Press simultaneously the
STOP
and
UP
button of the
GC228A
for at least 6 seconds: The Green
LED will first turn on solid and then blink a few times. When the Green LED turns off the
operation is completed.
NOTE: TO reset to previous mode of operation repeat the three steps above.
Specifications
Power:
110VAC / 60Hz
AC Input:
White = Neutral / Black = Line / Green = Earth
To the Motor:
White = Neutral / Red = Direction 1 / Black = Direction 2 / Green = Earth
Ambient T:
0 - 130°F
Installation
