16
Programming steps for Manual Remote Control
NOTE:
•
Before starting this procedure the Receiver must be without power (OFF) for at least 10 seconds.
•
During the programming function the interval between each step required must be less than 10
seconds
1.
Programming the GC 74DC-F to a Remote
a.
Turn on the power to the
GC 74DC-F:
a soft beep will be emitted by the RF receiver in the unit.
b.
Press twice the P2 button on the back of the Remote (A beep will be emitted by the RF receiver
with each press)
c.
Press the
UP
on the Remote Control, verify that the motor is turning in the correct direction. If the
motor turns in the opposite direction, repeat a. and b. and finish the process by pressing the
DOWN button.
2.
Programming the GC 74DC-F to an additional Remote
a.
Don’t turn off the power to the GC 74DC-F (If you do you will delete the previous remote!)
b.
Press
twice
the P2 button on the back of the first Remote (A beep will be emitted by the RF
receiver with each press)
c.
Press
once
the P2 button on the back of the additional Remote (A beep will be emitted by the RF
receiver)
d.
Press the
UP
or
DOWN
button on the Remote to verify that the unit is programmed
3.
Cancel all Remotes
a.
Turn on the power to the
GC 74DC-F:
a soft beep will be emitted by the RF receiver in the unit.
b.
Press the P2 button on the back of the Remote (A beep will be emitted by the RF receiver with
each press)
c.
Press once the
STOP
button of the Remote
d.
Press the P2 button of the Remote. Three beeps will be emitted by the RF receiver.
4.
Program “Continuous” or “Step” mode of operation
a.
Turn on power to
GC 74DC-F
b.
Press the P2 button on the Remote
c.
Press the
UP
button of the
GC 74DC-F.
d.
Press the P2 button on the Remote.
