21
The unit operates on a 3V DC2032 battery with a life of over two years and the operating condition of the unit
should be checked periodically by pushing upward on the extended Lead Rail and letting it drop to verify that the
system is working properly. A drop of 8” to 10” should cause the retraction the Lead Rail. The
GC 135-M
may also
be purchased configured to operate from a 12VDC power source.
To prevent discharging the battery due to accelerations caused by travel while the awning is closed, the transmitter is
turned off when placed in the proximity of the magnet mounted inside the cassette.
The three Dip Switches of the
GC 135-M
determine its mode of operation. The diagram in Fig. 2. Shows the Dip
Switches set as 1-ON / 2-ON / 3-OFF (The white square shows the position of the switch!). The proper settings for
the
GC 135-S
are as shown in Fig. 2. The function of switch 1 is to turn on the power to the transmitter and this is
shipped in the “off” position to preserve the battery state. Power will be applied after installation during the
programming step.
Fig. 2
Programming steps
NOTE:
•
Before starting this procedure the Receiver must be without power (OFF) for at least 10 seconds.
•
During the programming function the interval between each step required must be less than 10 seconds.
•
The Motion Sensor can only be programmed to a REMOTE that is already programmed to the Receiver.
To Program GC135M to a GC-136 Receiver
a)
Turn on the
GC-136
and the
GC135M
(Leave them on if already on)
b)
Press the
PROGRAM
button on the
GC-136
(the LED will start blinking)
c)
Press the
STOP
button on the
GC-136
(The LED will be on solid)
d)
Press the
UP
button on the
GC135M
e)
Extend awing using a Manual Remote Control and press again the
UP
button on the
GC135M
to
verify that the unit is working properly (the awning should Retract)
To Program GC135M to a Remote Motor or to GC74DC-F
a)
Program first the Remote Control to the
Remote Motor
or the
GC74DC-F
(See Remote Control
programming instructions
)
b)
Turn on the
Motor (or GC74DC-F)
(you will hear a faint beep from the RF receiver)
c)
Turn on the GC135M.
d)
Press TWICE the P2 button on the back of the programmed Remote Control
e)
Press ONCE the
SETUP
button on the
GC135M (
A beep will be emitted by the RF receiver with
each press).
f)
Extend awing using a Manual Remote Control and press again the
UP
button on the
GC135M
to
verify that the unit is working properly (the awning should Retract)
ON
1 2 3
