INSTALLATION
MANUAL
EN
MI_020
Rev.1
29/04/2020
Page 18 of 24
4.3.4
Installation of cupola
To make assembly easier, it is
best to assemble the swinging
arm first, and then the cupola.
Before positioning the cupola, as indicated in the drawing, position
the yoke lock covering (1) and the yoke lock (2) on the swinging arm
tube.
Insert the head of the Product with the yoke (3) on the swinging arm
and bring the surfaces into contact. Now the head is able to
maintain the position autonomously, without any support.
Pay attention to place the Product head and the arm in the same
position, as indicated in the drawing, with the yoke to the left of the
arm and the friction screw (4) turned downwards.
Push the yoke hub lock (2) onto the yoke hub (3), and rotate it in
order to match the corresponding 6 holes.
Screw the 6 screws (5) to lock the hub and lock.
Then position the cover (1) on the lock (2) in order to cover the
screws.
Connect the white connectors from the front part of the arm and
fasten the covering disc (6) in front of the yoke by screwing the
three screws (7).
In case of a lamp equipped with CCTV, the power connector and
the video signal connectors will have to be connected in
accordance with the letters.
4.3.5
Electrical connection
Electric shock hazard.
Before completing the installation, it is necessary to connect the
electrical system. To avoid any risk of electric shocks, the Product
must only be connected to mains supplies with earth protection.
Before making the Product power connections, make sure the
mains supply line has been interrupted.
GIMA does not supply the mains supply cables.
Prime the fuses in the switchboard terminal box after the
mechanical and electrical assembly of the Product. Priming the
fuses too early could permanently damage the Product. If the
Product is not used for long periods of time, remove the fuses.
For wiring connections in the
ceiling version, use a cable
suitable for at least 105°C and
connect the ground lead to the
terminal provided.
According to the different cases, the electronic panel could be
installed on the anchoring tube or in the false ceiling.
The line and neutral cables (L, N) from the power line have to be
connected into the terminal 1 and 2 for single light head lamps and
for double light heads to the terminals 1 and 2, 3 and 4.
Summary of Contents for GIMAled81
Page 37: ...MANUALE D USO E MANUTENZIONE IT MU_027 Rev 1 29 04 2020 Pag 13 di 33 Modello a piantana...
Page 57: ...MANUALE D USO E MANUTENZIONE IT MU_027 Rev 1 29 04 2020 Pag 33 di 33 Note...
Page 94: ...OPERATION AND MAINTENANCE MANUAL EN MU_027 Rev 1 29 04 2020 Page 13 of 33 Mobile model...
Page 114: ...OPERATION AND MAINTENANCE MANUAL EN MU_027 Rev 1 29 04 2020 Page 33 of 33 Notes...
