INSTALLATION
MANUAL
EN
MI_020
Rev.1
29/04/2020
Page 14 of 24
On the threaded bars (or pre-prepared tie rods) insert the nuts (3),
the washers (4) (secure them with adhesive tape on the tiges (bar)
to prevent them from falling) and insert the tiges (2).
Position the washers (5), nuts (6) and locknuts (7) from underneath.
Using the nuts (6) and locknuts (7), position the tiges tube vertically,
making sure it is correctly aligned using a spirit level (8).
Once in the balanced position, tighten the upper nuts (3) so that
everything is stable.
Make sure the product is stable.
Product falling hazard.
VERSION WITH COUNTER-PLATE
In case of counter-plate (optional), drill the holes as shown in
paragraph 4.2 and fix it to the ceiling.
To fasten the tiges to the counter-plate, follow the instructions given
above.
Make sure the mains power cable (1) can reach the lamp power
board without creating interferences with the Bar.
Fit the switchboard (2) on the Bar tube and tighten the two screws
(3) and their toothed washers (4). Position the switchboard so the
slot (5) of the retention bracket coincides with the hole M6 (6) on
the fastening tube. Make sure the switchboard is secure by
tightening the screw (7) and its toothed washer (8).
Summary of Contents for GIMAled81
Page 37: ...MANUALE D USO E MANUTENZIONE IT MU_027 Rev 1 29 04 2020 Pag 13 di 33 Modello a piantana...
Page 57: ...MANUALE D USO E MANUTENZIONE IT MU_027 Rev 1 29 04 2020 Pag 33 di 33 Note...
Page 94: ...OPERATION AND MAINTENANCE MANUAL EN MU_027 Rev 1 29 04 2020 Page 13 of 33 Mobile model...
Page 114: ...OPERATION AND MAINTENANCE MANUAL EN MU_027 Rev 1 29 04 2020 Page 33 of 33 Notes...
