Gima GIMAled81, Instruction Manual

Page: 67 / 114

INSTALLATION
MANUAL
EN
MI_020 Rev.1 29/04/2020 Page 10 of 24
The TECHNICAL SERVICE PERSONNEL has all technical, civil and legal
responsibility relating to correctly and suitably performing Product
anchoring and installation operations in a workmanlike manner.
3.2 Correctly wiring up the premises
Carry out safe electrical works.
The premises used for medical purposes must be safely wired up in
a workmanlike manner by TECHNICAL SERVICE PERSONNEL to power
the Product.
Make sure that the electrical
environment complies with the
law.
Before installing the Product, the TECHNICAL SERVICE PERSONNEL
must make sure the following conditions exist:
-
The wiring system of the environment (premises) in which
installation is made must be in conformity with regulations for
premises used for medical purposes and with applicable
national laws and/or regulations.
-
The electrical system must have a certificate of conformity
issued by whosoever installed it.
The earth system must be certified as required by applicable
regulations.
Main switch Position the thermal magnetic switch near the Product so that it can
be switched off in case of need.
CAUTION In case of mobile version do not position the device so it is hard to
reach and remove the power plug in case of an emergency.
4 Product installation
Before proceeding to install the Product, first of all check the
presence of all the packaging and that this is in good condition
and has not been damaged during transport.
Claims will only be taken into consideration if the seller or carrier
has been immediately notified. All claims must be made in
writing. Goods always travel under the responsibility and at the
risk of the buyer.
Keep the original packaging in case the Product has to be re-
dispatched.
Personnel required: (Two)
Necessary protection equipment:
•
Safety eyewear
•
Gloves
•
Accident-prevention footwear