GILES EOF-20, Operation & Service Manual

Page: 67 / 113

56
Fryer Operation
EOF 10-10/20
5-01.8 User Settings - Access & Edit
NAME DESCRIPTION RANGE DEFAULT
TEMP SCALE Temperature scale °F or °C °F
FORCE FILTER
When ON , forces user to filter oil after specified number of
cook cycles ... locks-out unit until performed .
ON - OFF ON
FORCE FILTER
SNOOZE
Allows (1) more cook cycle after FORCE FILTER count exceeded
when FORCE FILTER = ON.
ON -OFF OFF
FILTER COUNT Number of cook cycles before user is required to filter. 1 to 20 4
GUARD BAND
Cooking not allowed if oil temperature is outside of the setpoint
by amount of guard band
1 to 990 900
MAX SETPOINT Maximum oil setpoint allowed. 32°F to 350°F 350°
AUTOCOOL After a specified amount of time, unit will go into COOL mode. ON - OFF OFF
AUTOCOOL TIME
(MINUTES)
If AUTOCOOL is ON , then after fryer is idle for the amount of
time specified here, the unit will go into COOL mode.
1 to 510 minutes 30
AUDIBLE ALARM
(SECONDS)
Duration of the audible alarm in seconds. 5 to 120 seconds 10
COOL TEMP Temperature of the COOL mode 200°F to 350°F 275°F
BOIL TEMP Temperature of the BOIL OUT mode 185°F to 208°F 200°F
FILTER RESET Temperature that allows exiting of filter mode 200°F to 325°F 290°F
BOIL OUT TIME Time (in minutes) for BOIL OUT mode 1 to 45 minutes 30
STIR ALARM
ENABLE
If enabled, allows the stir alarm to come on during a cook cycle. ON - OFF ON
STIR ALARM %
When STIR ALARM is ON , the alarm will sound after this % of
the cooking cycle is complete.
10% to 90% 62%
KEY BEEP ENABLE If enabled, audible sound generated with each key press. ON - OFF OFF
Press the
TIME key
+
9 9 9 9
+
Use numeric keypad [4] & [6] (left/right) to scroll through list until
desired Setting is shown on the OLED Display .
To exit the USER SETTINGS menu, press the CLEAR key.
To edit the setting press the EDIT key ... Use numeric keypad
[2] & [8] (up/down) to change the value. Press EDIT again to
save the new value.
Press the
START key
NOTE:
The message TOO LOW or
TOO HIGH will be displayed
if a value being entered is
outside the allowable range
and would cause a Controller
error for the current state of
the Fryer.
Continued on Next Page