Gilera Runner Purejet 2007, Workshop Manual, Page: 51 / 257

Legshield
Rear rack
Lights list
The lighting system turns on when the key is
turned to ON.
It is possible to select the high beams using the
light switch.
If there are problems with the lighting system c h
e c k :
- Bulb efficiency
- The 7,5A fuse shown in the picture removing the
front casing
- Check using a multimeter that the GREY-RED cable of the plug with contacts has a voltage of +12V
- Check the GREY-BLUE cable of the light switch has a voltage of +12V
- Check efficiency of light switch
- Ensure the presence of earth to the bulb carriers.
See also
Legshield
Dry-charge battery
WARNING
THE BATTERY ELECTROLYTE IS POISONOUS AS IT MAY CAUSE SERIOUS BURNS. IT CON-
TAINS SULPHURIC ACID. AVOID CONTACT WITH THE EYES, THE SKIN AND CLOTHING. IF
COMING INTO CONTACT WITH EYES OR SKIN, WASH ABUNDANTLY WITH WATER FOR AP-
PROX. 15 MIN. AND SEEK IMMEDIATE MEDICAL ATTENTION.
IN THE EVENT OF ACCIDENTAL INGESTION OF THE LIQUID, IMMEDIATELY DRINK LARGE
QUANTITIES OF WATER OR MILK, MAGNESIUM MILK, BATTERED EGG OR VEGETABLE OIL.
SEEK IMMEDIATE MEDICAL ATTENTION.
THE BATTERIES PRODUCE EXPLOSIVE GAS; KEEP CLEAR OF NAKED FLAMES, SPARKS OR
CIGARETTES; VENTILATE THE AREA WHEN RECHARGING INDOORS.
ALWAYS WEAR EYE PROTECTION WHEN WORKING IN THE PROXIMITY OF BATTERIES.
KEEP OUT OF REACH OF CHILDREN
Characteristic
Battery
12V-9Ah
Commissioning dry-charge batteries:
1) Once the short closed tube and caps are removed, add sulphuric acid to the elements, of a type for
batteries with a specific gravity of 1.26, corresponding to 30° Bé at a temperature of at least 15°C until
reaching the upper level.
2) Let it sit for two hours.
3) Use the specific battery charger (single or multiple) to charge to an intensity equal to around 1/10 of
the capacity until the voltage has reached a value of around 2.7 V per element. The density of the acid
Runner Purejet
Electrical system
ELE SYS - 51