Gilera Runner Purejet 2007, Workshop Manual, Page: 119 / 257

PARAMETERS
Specification Desc./Quantity
ENGINE RPM Displays the regime of the engine in all conditions, including
the start-up
ENGINE TEMP. °C Indicates the coolant temperature
THROTTLE OPEN. % Indicates the % of opening of the throttle valve
T. FUEL INJECT. MS Time of opening the fuel injector
AIR INJECTION T. MS
Time of opening the air injector
(air- fuel spray)
ADVANCE IGN. ° Advance ignition in degrees before the TDC
VOLTAGE SENSOR V Denotes the voltage of the TPS sensor
TEMP. ENGINE V Denotes the voltage of the coolant temperature indicator
TPS1 OUTPUT V Indicates the TPS1 voltage indicator
TPS2 OUTPUT V Indicates the TPS2 voltage indicator
TPS1 RESET V Indicates the reset voltage of the TPS1 indicator (voltage re-
ferring to the ground)
TPS2 RESET V Indicates the reset voltage of the TPS2 indicator (voltage re-
ferring to the positive 5V)
VOLT. BATT. V Indicates the power supply voltage of the ECU (normally iden-
tical to the power of the vehicle battery)
T. OF DWELL MS Indicates the core dwell time of the H.V. coil
MIN RPM Indicates the number of engine revolutions set in the ECU for
checking the minimum
INST. CONS.L/H Indicates instantaneous fuel consumption
D. CYCLE CONS. % Indicates the ratio in % between the time in "ON" and the time
in "OFF" of the consumption meter control indicator (this vehi-
cle is not fitted with this instrument)
ENGINE STATUS Displays the status of the engine:
STALL (stopped)
CRANK (start up)
IDLE (minimum)
RUN (gear)
ORC (limit on revolutions in progress)
RUNNING HOURS Displays the engine running time (in hours)
S.T. FUEL PUMP. Denotes the status of the fuel pump (OFF - ON)
TPS TO RESET Indicates the need to repeat the reset of the TPS indicators
(YES- NO)
ERRORS
Specification Desc./Quantity
G11 P0115 Engine temperature indicator: the voltage of the
coolant temperature indicator is near 0V (short cir-
cuit) or 5V (open circuit).
Temperature indicator off
Light off
G11 P0217
Engine temperature high: the coolant tempera-
ture signal voltage has reached too low voltages.
They denote a very high temperature, higher than
what can be indicated by the instrument panel.
Flashing light
G20 P1120 TPS OFFSET
The voltage of TPS signals is not as expected.
Engine is in idle.
Light on
G20 P1123 TPS TPS signals missing
Voltage close to 0V (short circuit)
Voltage close to 5V (open circuit)
Engine to forced idle
Flashing light
G21 P1124 TPS1 OFFSET
TPS1 signal is not as expected.
Runner Purejet
pure jet injection
INJ PJ - 119