9
3.5
Installing (optional) lock
Toothed-belt lock
1. Place the locking device on two sliding blocks at the correct distance (see block
diagram) from the deflection pulley and screw it down with M6 x 16 Inbus-Ripp
locking bolts.
2. Test the locking function: Lock and unlock bolt (1).
The bolt must move smoothly.
Bolt lock
See installation instructions Id. No. 106944
Use only toothed-belt lock with "24 V" label!
1
Remove the red actuating pin before mounting the hood, then screw in again.
After installing the toothed belt, check (click) the switching point of the indicator
switch and adjust by bending the actuator lever if necessary.
