27
Installing display program switch
For electrical installation, see terminal connection diagram.
Installing key switch
The display program switch can be engaged/disengaged with the key switch.
For electrical installation, see terminal connection diagram.
4.3
Commissioning
Connecting cables
1. Disconnect the system from the 230 V mains network.
2. Carry out cable routing in an orderly manner in accordance with terminal
connection diagram:
Use cable take-up in the end pieces and cable holders. Cut out breaks in the side
panel if necessary.
3. Make connections to the controller based on the terminal connection diagram.
4. Before start-up, ensure that all cables are secured with cable ties and kept clear
of any moving parts within the drive unit.
Starting Learn function
1. Push the display program switch into the controller.
2. Clear out detection field of all sensors.
Use display program switch DCU (Id. No. 103940) only!
The key switch is required with the Slimdrive SL-FR 2M!
The key switch is optional with the Slimdrive SL.
Danger of electric shock!
➮
The electrical system (230 V) may only be connected and disconnected by a
qualified electrician.
➮
Perform the power connection and equipment earth conductor test in
accordance with VDE 0100 Part 610.
•
If flexible cables are used, attach insulated wire-end ferrules.
•
The battery must be fully charged.
Danger of crushing!
Door leaves move, all the safety equipment on the door is deactivated.
➮
Step back out of the door path.
Danger of injury by opened drive!
Hair, clothing, cables etc. can be pulled in by rotating parts!
➮
When working on open drive, be cautious of rotating parts.
