7
3 Premounting
3.1
Preparing profiles
See block diagram for lengths and processing of profiles.
3.2
Preparing runner
1. Measure centre of drive and mark on runner.
2. Push all sliding blocks (1) and the earth connector into mounting groove.
See the block diagram for the number and sequence of sliding blocks
.
3. Measure out position of the components based on the block diagram.
3.3
Installing deflection pulley
➮
Place the deflection pulley (1) on two sliding blocks at a distance U1 (see block
diagram) from the centre marking and install it with an M6 x 16 Inbus-Ripp locking
bolt.
1
When measuring out the drive centre, keep drive extension in mind!
Note differences between sliding blocks.
1
