GET ECULMB EFI 2T ECU, Installation Manual

Page: 3 / 88

3 EN
4. When GET ECULMB is installed, if an OEM air filter and/or
and OEM exhaust system are not installed on the bike, this
could lead the engine to lose power. To fully exploit engine
performance, use only original air filter and exhaust system.
5. To use and manage the GPA technology, it is necessary
to install GET GPA Switch or GET LC-GPA module (both sold
separately) or manage it with GET Maya Software (sold
separately).
6. To change GET ECULMB injection map, it is necessary to use
GET Maya programming software (sold separately).
7. If the bike does not start or the engine is irregular, be sure
that the version of GET ECULMB chosen is compatible with
your bike model and year. Verify that ECULMB is properly
connected and perform a TPS calibration (see section F.
TUNING - ZERO TPS CALIBRATION).
8. Do not remove the thermostatic valve: removing it may
cause damage and/or malfunction.
9. Keep the exhaust control OEM setting measurement to
avoid engine malfunctions:
300cc engines: 2,3 mm (0.091“)
250cc engines: 2,7 mm (0.106“)
10. Use only OEM spark plugs to avoid engine malfunctions.
Check the proper spark plug model on your vehicle manual.
11. Periodically check the engine compression ratio (see your
motorcycle manual) to avoid malfunctions and to fully exploit
GET ECULMB.