Georgia Institute of Technology AutoRally, Instructions Manual

Page: 62 / 92

23 GPS BOX ASSEMBLY
e. Referring to the diagram above, solder one end of the resistor to the white wire in the GPS
cable. Solder the ribbon cable corresponding to the white wire to this junction. Solder all of
the ground wires from the ribbon cable together.
Remember to slip a small piece of heat
shrink over the ribbon cable wire before soldering.
f. Solder a small piece of black servo wire to the other end of the resistor. Slide a small piece of
heat shrink over the resistor and the solder joind between the resistor and the black servo wire.
Solder the other end of the black servo wire to the ribbon cable ground wires, the black lead of
a 4” piece of servo cable, and the ground lead of the fan.
Remember to put a piece of heat
shrink over the ribbon cable ground leads before soldering.
g. Referring to the wiring diagram above, solder the red and yellow leads of the same servo cable
to the corresponding wires in the ribbon cable and fan. Remember to slide a small piece
of heat shrink over the wires before soldering.
h. Tin the leads on the other end of the servo cable.
i. Referring to the wiring diagram above, solder another 4” piece of servo cable to the corresponding
58