15
CUT ROLL CAGE
i. Ensure that the rubber tire material is properly seated into the respective slots. Then ensure
that the rims slots properly align with the tire material.
ii. This step may require more than one person.
f. Make sure the beadlocks sit flat and do not pucker when the screws are installed. If there is
puckering, loosen the screws, realign the tire rubber and then retighten. Properly seated rubber
inserts will make it easier to get the beadlock to sit flush against the tire.
The photos show
good and bad examples of seated beadlocks.
g. The photos below show bad examples
h. The photos below show acceptable examples
15 Cut Roll Cage
Time
0 hours 10 minutes
Parts
•
Large zip ties
•
Roll cage from Baja 5SC
Instructions
a. Cut the roll cage just in front of the rear shock tower. The blue tape in the photos below shows
the approximate location at which to cut.
33
Summary of Contents for AutoRally
