5
CAPACITOR PRECHARGE CIRCUIT
f. Solder the unbent lead of the resistor to female 4mm connector wire and heat shrink the con-
nection.
g. Remove the heat shrink from the red battery bullet connector. Cut away a small portion of
insulation on one side of the red battery lead close to the bullet connectors and on one side of
the red ESC power wire.It may help to tin the exposed wire to help with the upcoming soldering.
h. Solder the male 4mm connector wire to the exposed wire of the red ESC power wire. Heat shrink
the exposed section of wire.
i. Solder the bent end of the resistor to the exposed wire on the battery. Heat shrink over the
connector and resistor.
8
Summary of Contents for AutoRally
