Check & Adjust -3
REMARKS
：
1.
A
: adjust
C
: clean
I
: inspect, or replace if necessary
L
: lubricate
R
: replace
2.
Items with “*” mark indicate our recommendation to have it done by GENUINE dealer.
NOTE 1
：
For 4T engine, the engine oil shall be changed completely after run-in period 200mile or one month later. This can
make sure the engine runs smoothly.
NOTE 2
：
The exchange of brake fluid
1.
After disassembling of brake main cylinder or caliper, do change the new fluid.
2.
Check the fluid level often, Refill if necessary.
3.
Change the oil seal of main cylinder and caliper every two years.
4.
Change the brake fluid hose every four years.
Exhaust control system (only be valid for the bike equipped catalyst):
Catalyster will not be possible to be withdrawn individual, the only you have to do is to maintain fuel, ignition,
intake/exhaust system periodically.
1.
Maintenance procedure of air clearer (see page 35).
2.
Spark plug’s checking: please repair or replace if spark plug is dirty.
3.
Fuel system’s checking: please repair or replace if fuel pipe is jammed or broken.
4.
Muffler’s checking: please fix tightly once or renew a gasket if it is leaking.
5.
Idle rpm’s checking: please fix tightly once or renew a gasket if throttle cable.
6.
Exhaust density checking while idle: please left the job to any service center of anti-pollution inspection for
carburetor adjusting.
64
